Shift knob installation, help pic inside.

i have this shift knob that i wanna install on my civic.
i took out the original knob and try to install the new one. the new seems too big for my shifter shaft. the hole is too large for the shaft.
in the box it says it's univeral shift knob and if necessary, use the adapter to fit it.

and this is the adapter


i dunno wtf to do with this lil things. any help? :dunno:

First unscrew the bottom part of the shifter, slide is onto the rod. You should see 4 holes for the screws to go in once the bottom end if off, then simply slide the shifter on the rod and then tighten each little screw little by little with the allen key. Make sure you try and tighten evenly so the the shifter is tightly fastened with the 4 screws, its really easy, takes max 5 minutes

Ridin LO said:

First unscrew the bottom part of the shifter, slide is onto the rod. You should see 4 holes for the screws to go in once the bottom end if off, then simply slide the shifter on the rod and then tighten each little screw little by little with the allen key. Make sure you try and tighten evenly so the the shifter is tightly fastened with the 4 screws, its really easy, takes max 5 minutes

Click to expand...

pas tout a fait, si ya trop de lousse entre le shift knob pis le shaft y va se slaquer tout seul, sa te prend un tit adapteur en plastique noir que tu vise sur le shaft (tu le vis comme on vis lancien shift knob) ensuite tu force ton nouveau shift knob pour qui rentre dedans, et la tu vis tes 4 vis.

D'habitude il fournisse les adapteur noir en plastique mais on dirait que ten a pas eu toi. J'ai deux set d'adapteur dans mon char mais ye au garage a St-Sophie et je l'aurais pas avant la semaine prochaine (lundi ou mardi) fak si d'ici la ta pas reussi a le mettre, tu viendra me voir ma te donner un adapteur qui fit ton shaft!

Fred

Ridin LO said:

First unscrew the bottom part of the shifter, slide is onto the rod. You should see 4 holes for the screws to go in once the bottom end if off, then simply slide the shifter on the rod and then tighten each little screw little by little with the allen key. Make sure you try and tighten evenly so the the shifter is tightly fastened with the 4 screws, its really easy, takes max 5 minutes

Click to expand...

nice i did it. thx dude, lol i didn't know that i can unscrew the bottom part
*tu*