A Couple Questions Before I Install My Suspension ...

Status
Not open for further replies.
I

Italian_Bora

New member
I have a fk 55/40 - bilstein setup on my jetta, im gonna be installing them in the next week ... when i get this installed is there any bushings or things like that i can get taken off to make it sit a bit lower in the back?

and does anyone have any suggestions were i can get it installed and how much i should pay for it around ?

thanx
 
Last edited:
Ht

Check out HT TURBOTECH *450-444-4816* they have great prices,
and great service, im getting my suspension installed there on
thrusday for my mk3 jetta*tu*
 
it's the rubber part where the spring sits...you can take it out and sit a bit lower but you'll have metal on metal...
 
Turbora13 said:
it's the rubber part where the spring sits...you can take it out and sit a bit lower but you'll have metal on metal...
Click to expand...

Well forget about that lol .. no its because i remember hearing something about removing perches but i did a search on vortex and i realised it was just for coilovers ... thanx guys !
 
Hey, you ask for a way to lower the coils, that's the way to do it if you don't wanna cough up the money for coilovers.
 
Remove the rear perches then. And lowering caps don't always work. Just go buy some Vmaxx coilovers esti.
 
jmexx said:
Remove the rear perches then. And lowering caps don't always work. Just go buy some Vmaxx coilovers esti.
Click to expand...


i simply asked if there was anything i can do to make it a bit lower in the back ... i like this drop ... and if i remember correctly i read a thread u made about lowering caps and did anyone tell you to go buy coilovers ... esti
 
Status
Not open for further replies.
Back
Top