loading a bike

Status
Not open for further replies.

Barq

New member
whats the best way to load a bike onto a pickup truck.. i seen a couple of youtube videos andddd its getting me kinda nervouse.. any suggestions would be greatly appreciated:)
 
Best way is a ramp but when no ramp 3 guys are needed. Two to lift and one to hold the balance in the truck.
Going on a stealing spree? :p
 
facile tu prends un long madrier de bois tu l'accote sur la gate du pickup pis tu pousse la moto dessus gentillement
 
Its very easy.

My buddy and I took his truck + a ramp he constructed (which was surprisingly strong enough to hold 3 guys on, who are at least 200lbs+ each).

Here are some pics of the day back in April when I went to pick up my bike at the dealership.




a3994a32.jpg


d382832d.jpg


c03d16b0.jpg


a5b56fef.jpg


760e0216.jpg


035456d8.jpg


db01fa36.jpg




With this setup we drove from Anjou to the West-Island, about a good 60kms on highway at speeds of 100-110kph, the bike was solid and didn't budge a bit.

Hope this helps *tu*
 
strap sur le tripple clamp...sur les clip-on c'est dur sur le throttle tube.
et un petit madrier de 8"ou 10" x 8' est ben en masse.
je monte mon bike seul, mais a 2 ca va mieux
 
thnx guys helped me out alot i also ended up building a ramp n strapping it like you guys said .. the r6 fit very nice :)
 
Status
Not open for further replies.
Back
Top